Compact size

The JBL Club A600 amplifier features a low-profile chassis and a small overall footprint to fit in more vehicles where available space is limited.

High and low level input

Speaker-level and low-level inputs allow the Club A600 to integrate with both aftermarket and factory car stereo systems.

Variable crossover and bass boost

Unlike many amplifiers available at similar prices, the JBL Club A600 features variable electronic crossovers and bass boost circuits allowing for precise system tuning and performance.

Low noise and distortion

The Club A600 has been engineered using Balanced Differential Inputs to ensure low noise and distortion even at high output levels. This also makes it far less susceptible to line induced radiated engine noise.

Input Level Control

When the low-level inputs are used, this control adjusts the input sensitivity between 200mVrms and 2.0 Vrms. When high-level inputs are used, this control adjusts the input sensitivity between 2Vrms and 20Vrms.

Full on-board protection

On-board circuitry protects the Club A600 from shorts, high-temperature, overvoltage and undervoltage. An LED indicator is provided to let you know when one of these conditions exists.

Phase Switch

This switch changes the input phase to inverted or non-inverted. This is especially helpful with the subwoofer channel.

RBC wired remote

The RBC wired remote is an easy installation and can be mounted for convenient volume adjustment from driver's seat.

Audio Specifications

350 watts RMS x 1 at 4 ohms (600 watts RMS x 1 at 2 ohms)
variable low-pass filter (32-320 Hz, 12 dB/octave)
variable bass boost (0-12 dB at 45Hz)
phase switch (0, 180 degrees)

General Specifications

Class D amp technology
preamp and speaker-level inputs
8-gauge power and ground leads recommended
WxHxD=220mm x 51.3mm x 180mm

What's in the box

1 x Club A600 mono subwoofer car amplifier
4 x 30A ATO fuses (2 installed, 2 spare)
2 x Bare wire-to-RCA adapters
1 x Remote bass control module
1 x 16.5' Remote control cable (RJ-25 plugs on both ends)
2 x Self-tapping screws for remote (M3 x 15mm)
4 x Mounting screws (M4 x 53mm)
2 x JBL stickers
1 x Owner's manual